BELLAMI Silk Seam Clip In Extensions

STEP 1 – SEPARATE YOUR HAIR

Starting at the lower back section of your head, use a tail comb or index finger to divide (horizontally part) your hair, at the lower back of the head i.e. just below one ear to the second ear.

*Also, you can start parting even lower, as low as you want to place the first weft*

STEP 2 – SECTION YOUR HAIR

BELLAMI Silk SeamTM Clip in Hair Extensions should be attached from the bottom up. Starting at the lowest point on the hairline, and using a tail comb or your index fingers, create a part where you wish to section off the hair.

STEP 3 – CLIP UP YOUR HAIR

Clip your remaining hair, firmly on the top of your head, to keep it out of the way as you fit the wefts.

STEP 4 – PREPARE THE FIRST WEFT

Take the first weft from your pack of BELLAMI Silk SeamTM Clip in Hair Extensions. The first weft should be long enough so that the weft is wide enough to sit along the back of your hairline. Then open all the clips so they are ready to be inserted into your hair.

STEP 5 – PLACEMENT OF THE FIRST WEFT

Next, take one of the wider hair wefts and insert the opened center clip just below the parting. Insert the snap clip on your hair, not on the raw scalp. Snap the clip shut, so it grips your hair. Repeat with the remaining clips.

STEP 6 – CREATE A NEW PARTING

Release the hair you held out of the way and create a new parting. To do this, comb down a layer of hair, with about half an inch or so between each weft layer. Each time secure the extra hair, on top of your head.

STEP 7 – PLACEMENT OF THE REMAINING WEFTS

Now insert the remaining wefts in the same manner as above. Repeat the process with a new parting above each weft extension.

STEP 8 – CHECK FOR GAPS

Now that your BELLAMI Silk Seam Clip in Hair Extensions are attached, run your fingers along the weft to make sure it lies flat against your head along the entire width. If there are any gaps, correct this by snapping the clip open, lifting it off the hair and re-positioning it so that the weft lies flat.

STEP 9 – PLACEMENT OF THE SIDE PIECES

Insert and position the 4 side pieces so they frame the face and blend with your own hair.

STEP 10 – REMOVING THE HAIR WEFTS

To remove BELLAMI Silk Seam Clip in Hair Extensions, snap open all the clips and gently lift up and away from your hair. Never try to remove a weft without first opening all the clips.

Click here for a picture step by step tutorial on how to install clip-in extensions

More questions? Click here for Bellami Frequently Asked Questions

BELLAMI Silk Seam^TM wefts are significantly thinner than traditional lace wefts, allowing them to lay flat to the head and making them virtually undetectable.

• Crafted with the highest quality human hair
• Up to 30%* thinner and virtually undetectable with Invisi-Weft® technology
• More comfortable, longer lasting, and less shedding than traditional hair extensions
• 100% Remy Human Hair

*Up to 30% thinner than BELLAMI standard clip-in wefts with Invisi-Weft® technology. Due to the natural variance in human hair, exact weights may vary slightly.

Silk Seam 26" 360g Range Contains:

1 x 4-Clip Weft (8 inch)
1 x 4-Clip Weft (7 inch)
2 x 3-Clip Weft
3 x 2-Clip Weft